Roger PRT12 v1.3, Инструкция по установке и программированию

Страница: 9 / 40

PRT12 v1.3 fv75.6 EN Rev.D.doc 10/22/2007
_________________________________________________________________________________________
Page 9 of 40
6. Functional description for Offline mode
6.1. Users
In the Offline ( Stand-alone) mode, a PRT reader can register up to 120 users, each
with a card, PIN code (3-6 digits) and ID number (000–119). Each entry of a PIN
code must be followed by the [#] key which is required to mark an end of a PIN.
Users can be identified by their PINs or cards. When the
Card and PIN Identification
Mode is set, users must present their card and subsequently enter its PIN (always
first read card and then enter PIN). The Card and PIN option can be set separately
for primary and secondary reader.
The PRT12 reader supports five types (classes) of users:
 INSTALLER
 MASTER
 NORMAL
 TOGGLE
 TOGGLE LTD
User Types (user classes)
INSTALLER
This user is authorized for entry to the Installer Programming mode only. Enter
INSTALLER PIN or read INSTALLER card and the reader will enter Installer
Programming mode.
MASTER
This user is authorized for entry to the User Programming mode only. Enter
MASTER PIN or read MASTER card and the reader will enter User Programming
mode.
NORMAL
NORMAL users are solely authorized to unlock the controlled door, they may have
card and/or PIN.
TOGGLE
TOGGLE users are authorized to unlock the controlled door and to control the
Armed/Disarmed mode of the reader, they may have card and/or PIN.
TOGGLE LTD
TOGGL LTD (=TOGGLE LIMITED) are solely authorized to control the
Armed/Disarmed mode of the reader, they may have card and/or PIN.
6.2. Managing the users
A new user can be registered in the device following either a simple or full
programming procedure.
 The simple programming procedure consists of programming of a PIN code or
card into the unit without specifying the ID number of a user to whom the
programmed PIN/card will be assigned — so the system simply stores the code
entered/card presented in unoccupied ID number.
 The full programming procedure requires to specify the ID number for the new
user being programmed which has to be followed by entering his PIN code
and/or presenting his card.