Roger PRT12 v1.3, Инструкция по установке и программированию

Страница: 17 / 40

PRT12 v1.3 fv75.6 EN Rev.D.doc 10/22/2007
_________________________________________________________________________________________
Page 17 of 40
Note: If you observe that after selection of a reader’s operation mode or after
power up of a unit, the LED SYSTEM is on and accompanied with acoustic signal
it means that the contents of reader’s memory is corrupted or the
MASTER/INSTALLER card are not programmed. In this case you must perform the
full
Memory Reset and completely re-program a reader.
Example: Configuring the PRT12 reader for Online Wiegand 66 bit interface
 Power down the unit
 Remove all connections from DTA and IN1 lines.
 Connect DTA to IN1
 Restore power, the reader generates a continuous beep
 Wait until the LED SYSTEM starts flashing
 Disconnect DTA from IN1
 Press [7]
 Wait for the prompt signal (two short beeps)
 Press [0]
 Once the previous step is completed the reader is configured for Wiegand 66 bit
operation mode
7.4. Memory Reset - programming MASTER and INSTALLER
users
The Memory Reset erases all cards and PINs including card/PIN for MASTER and
INSTALLER. Also, it causes the reader restores the factory-shipped default settings.
The
Memory Reset has practical sense for Offline modes only, it does not affect the
unit if it is configured for Online mode.
To perform Memory Reset follow these steps:
 Power down the unit
 Remove all connections from CLK and IN1 lines
 Connect CLK to IN1
 Restore power, the reader will generate a continuous signal
 Wait until the LED OPEN starts flashing
 Disconnect CLK from IN1
 Enter PIN code for MASTER (e.g. 1111#) or skip this step and go to the next
one
 Present any card to the reader, this card becomes a new MASTER card or if you
don’t want to program MASTER card, press [#] – reader will skip this
programming step and will jump to the next one
 Enter PIN code for INSTALLER (e.g. 2222#) or skip this step and jump to the
next one
 Present any card to the reader, this card becomes a new INSTALLER card or if
you don’t want to program INSTALLER card, press [#] – reader will skip this
programming step and will jump to next one
 Once the previous step has been completed reader automatically ends the
Memory Reset and enters the Armed mode
Note: For MASTER and INSTALLER you may program PIN, card or both of them (i.e.
PIN and card). Only one form of identification (card or PIN) is required to enter