Roger PRT12 v1.3, Инструкция по установке и программированию

Страница: 13 / 40

PRT12 v1.3 fv75.6 EN Rev.D.doc 10/22/2007
_________________________________________________________________________________________
Page 13 of 40
The PRT12 reader is equipped with two functional keys: [F1]- Door bell and [F2] –
Light bulb . The function of each functional key depends on reader’s operating
mode.
When in RACS Offline mode, pressing function key will cause transmission of an
adequate code to the host controller which may further take adequate action (e.g.
trigger
Door Bell or Light output). The reaction of a host controller for functional
keys depends on its configuration. Always refer to controller’s settings when
configuring functional keys on a reader.
When in Wiegand Online mode, pressing of the F1 and F2 will causes following
codes send over the CLK and DTA output lines:
F1=C (hex)
F2=D (hex)
When in Magstripe Online mode pressing of the F1 and F2 causes following codes
send over CLK and DTA output lines:
F1=FF FF FF FF BC (hex ) or 1099511627708 (dec)
F2=FF FF FF FF BD (hex) or 1099511627709 (dec)
When in Offline mode (either Full or Simple ) pressing of F1 or F2 will always results
in triggering of a Door Bell output (if programmed).
6.10. Alarms
The PRT12 reader can detect and indicate following alarm types:
 Forced Entry
 Prealarm
 Door Ajar
Forced Entry and Door Ajar alarms will occur only if the reader operates with a
Door Contact . The alarm indication is carried out over the dedicated output line:
Alarm Output and optionally on the internal buzzer (see option: Door alarm
indication on internal buzzer ). For each type of alarm the PRT12 uses different
signal modulation of an output.