Roger PRT12 v1.3, Инструкция по установке и программированию

Страница: 20 / 40

PRT12 v1.3 fv75.6 EN Rev.D.doc 10/22/2007
_________________________________________________________________________________________
Page 20 of 40
C10 0 – 1
The Identification Mode for primary (main) reader:
[0] - Card or PIN
[1] - Card and PIN
C11 0 – 1
The Identification Mode for secondary (auxiliary) reader:
[0] - Card or PIN
[1] - Card and PIN
C12 0 – 1
Option: Door alarm indication on internal buzzer
[0] – Disabled
[1] – Enabled
C13 0 – 1
Option: Access disabled when reader armed
[0] – Disabled
[1] – Enabled
Note: Depending of the selected reader operation mode (either Full stand-alone or
Simple stand-alone ) the parameters C5 and C6 may refer to REL1 and REL2 output
lines on remote XM-2 I/O extension module or to CLK and DTA lines located on a
reader.
Example: Configuring the reader in the Installer Programming mode
Read your INSTALLER card once, the reader enters Installer Programming mode
(the LED OPEN is on and the LED STATUS lights in green) then enter following
set of digits (13 digits): 0206451230001. These digits configure a reader for
following options:
 Door unlock time : 2 sec.
 Door open timeout : 6 sec.
 CLK or REL1 line function: Door Lock output
 DTA or REL2 line function: Disarmed Mode output
 Line IN1 on the reader: Door Contact input
 Line IN1 on the XM-2 module: Exit Button input
 Line IN2 on the XM-2 module: Arming disabled input
 Identification Mode on primary reader: Card or PIN
 Identification Mode on secondary reader: Card or PIN
 Option: Door alarm indication on internal buzzer disabled
 Option: Access disabled when reader armed disabled
Last step completes the programming and the reader automatically leaves Installer
Programming mode and returns to the operating mode (either Armed or Disarmed )
to which it was in before entering Installer Programming .
Note: Installer Programming can be accessed only if the reader was earlier
configured for either Full Stand-alone or Simple Stand-alone mode.