EN
10
9
12 INSTALLING THE BOOM
IMPORTANT:
The BIONIK8 barrier is supplied with two 4.1 m booms (
D1
and
D2
).
WARNING!:
to avoid damaging the surface of the components, it is recommended to place them on a stable and soft surface.
• Unlock the barrier (see chapter 23).
• Turn the linkage lever into the position necessary for installing the boom horizontally.
• Lock the barrier.
12.1
D1 boom preparation (fig. 9)
• Remove the plug
Q1
and the end flange
R1
. These two parts will NOT be used again.
• Remove the led cover
N1
and shorten it by 285 mm from the side where it is fastened to the boom support.
• Remove the protective rubber
P1
and shorten it by 285 mm from the side where it is fastened to the boom support.
• Cut the excessive protective rubber at the opposite end as well.
12.2
D2 boom preparation (fig. 10)
• Remove the plug
Q2
and the end flange
R2
.
• Remove the led cover
N2
and the protective rubber
P2
.
CAUTION
: these two components should NOT be cut.
285
P1
D1
Q1
R1
N1
285
P2
Q2
R2
D2
N2
