Rodenstock REM 3000, Инструкция по эксплуатации

Страница: 82 / 109

3.6.5 LAN
(1)
(2)
(3)
(4)
(5)
(Fig. 1)
(6)
My IP Setting Type (1)
This setting enables you to select whether or not DHCP
is used for setting the IP address (local address, subnet
mask, default gateway).
DHCP : Setting with DHCP (dynamic IP).
Manual : Manual setting (fixed IP).
My IP Address (2), Subnet Mask (3), Default Gateway (4)
When Manual is selected as My IP Setting Type (1),
local address, subnet mask, default gateway are
specified.
LAN Connection Test (5)
Touch this button to confirm the connection with the
server. The result is displayed on (6).
Connection Status of LAN Communication (6)
Shows the status of LAN communication.
Connect
: Shows that it is connected.
Check LAN Cable : Shows that it is disconnected.
Even when this is displayed, the
connection test will be continued
for 60 seconds.
Server not found : Cannot communicate with the
server PC software.
n If only this instrument and a computer receiving DATA Transfer are connected to the
network, they can be set as follows.
1) Checking the computer's IP address
Check and note the IP address and subnet mask of the computer on which the DATA
Transfer software is installed. For details on how to check these items, refer to the DATA
Transfer instruction manual.
2) Setting method for this instrument
The example shown in the table below is for a computer with the DATA Transfer
3-40
Example
My IP Setting Type DHCP Manual
0. 0. 0. 0
0. 0. 0. 0
LAN Connection Test Test