Rockwell Automation Sensia Jiskoot InSpec Remote I/O HUB, Инструкция по установке, эксплуатации и обслуживанию

Страница: 16 / 40

Section 4: Field Connections InSpec Remote I/O HUB (ATEX, IECEx)
16
SIGNALS
Safety Extra Low Voltage (SELV) Circuits
Connect only SELV circuits to the RIO-DIO, RIO-PUL, RIO-ANI or RIO-ANO modules.
RELAY CIRCUITS (OUTPUTS)
The Remote I/O Hub requires different relay modules to switch AC and DC loads. Please
check carefully that the load voltage matches the relay type fitted.

Crydom # CN024D24 = 24V DC Load Voltage @ 1 Amp Max.

Crydom # CN240A24 = 100-240V AC Load Voltage (50/60Hz) @ 1 Amp Max.
Relay Output / Load Relay Output / Load
Model RL1 RL2 RL3 RL4 Model RL1 RL2 RL3 RL4
# ## 0 # ### ## AC AC AC AC # ## 8 ## #### DC AC AC AC
# ## 1 # ### ## AC AC AC DC # ## 9 ## #### DC AC AC DC
# ## 2 # ### ##
AC AC DC AC
# ## A ## ####
DC AC DC AC
# ## 3 # ### ## AC AC DC DC # ## B ## #### DC AC DC DC
# ## 4 # ### ##
AC DC AC AC
# ## C ## ####
DC DC AC AC
# ## 5 # ### ## AC DC AC DC # ## D ## #### DC DC AC DC
# ## 6 # ### ## AC DC DC AC # ## E ## #### DC DC DC AC
# ## 7 # ### ## AC DC DC DC # ## F ## #### DC DC DC DC
# ## X ## #### No relays fitted
Terminals 11 (13+) and 14 on each relay (RL1, RL2, RL3 & RL4) provide connections to the relays outputs,
controlled via the first RIO-DIO module, as follows:
Terminal
Duty
AC DC
11 (13+) +
14 -
The relay outputs can switch circuits designated as Installation Category III. Each relay output may switch a
maximum of 250VAC rms or 30VDC and is rated for 1 Amp resistive or inductive load at 60°C (140°F). All wiring
connected to any relay output must have a suitably sized protection device fitted to protect the relay circuit and
load being switched by it.
11
14
Fuse
1, 2, 3 or 4
AC LOAD
F2
AC Relay
Output
11
14
Fuse
5, 6, 7 or 8
DC LOAD
F3
DC Relay
Output