10000229312
00
G. FILLUS
12-22-11
7
12
B
210mm W x 297mm H
8 - 1/2" W x 11" H
CUT SIZE
1
Set dip switch S2 positions 2,3
& 4 to ‘ON’, all others to ‘OFF’
2
3a
3b
4
•
•
•
•
TO RECORD A MESSAGE ON STAGE 1 USING THE ON-BOARD MICROPHONE
For Stage 1:
For Stage 2:
For Stage 3:
For Stage 4:
RECORD MODE
(NOTE: “Black” color indicates “ON” position)
Set Switch ‘S2’ positions 3 & 4
to ‘ON’; all others to ‘OFF’
Set Switch ‘S2’ positions 2 & 4
to ‘ON’; all others to ‘OFF’
Set Switch ‘S2’ positions 4 to
‘ON’; all others to ‘OFF’
Switch on power or
Press reset button
Press and release action button:
Start recording
Speak into the on-board
microphone (MIC)
It is suggested that a 2” (5cm)
gap be maintained to the
microphone.
The peak detector LED should
flash regularly to maintain a
good recording level.
However, if it stays on for most
of the time, the recording may
be distorted.
Press action button:
Stop recording
TO RECORD FROM AUDIO LINE-IN JACK INSTEAD OF THE ON BOARD MICROPHONE:
Ensure that the audio cable is connected from the message source to audio line-in jack
before recording.
Follow above step 1 but set Switch ‘S2’ position 4 to ‘OFF’ for each stage.
At step 3b, play recording from message source. You will be able to listen as it is
recorded.
IMPORTANT NOTE
After the unit is configured, it must be put into its Playback Mode to operate.
Set switch S2 to stage 1, as shown in Playback Mode chart (next page).
7
INSTRUCTION SHEET
FOR BUL. 855H
RECORDABLE HORN FRAME E
TA
ON
RA
R/E
TA
ON
RA
R/E
TA
ON
RA
R/E
TA
ON
RA
R/E
PEAK
TA
ON
RA
R/E
