10000229312
00
G. FILLUS
12-22-11
2
12
B
210mm W x 297mm H
8 - 1/2" W x 11" H
CUT SIZE
INSTALLATION & WIRING REQUIREMENTS:
The power terminals on the control unit are clearly marked and will accept up to AWG 16 (1.5mm²) wire size.
2
FRAME E UNITS:
Remove 4 screws on face of unit for access to
power connections, programming
functions, and stage selection connections.
Re-torque as indicated after set-up to
maintain ingress rating.
FLARE UNITS:
ACCESS TO PCB’S FOR PROGRAMMING AND POWER CONNECTIONS
FRAME E
FLARE
TONE SELECTION
The 855H Recordable Horn has 45 different tones (See page 12) that can be selected for the first stage alarm. The
unit can then be switched to sound second, third and fourth stage alarm tones. The tones are selected by
operation of DIP switch S4 on the main PCB.
The tone selection table (page 12) shows the switch positions for the 45 tones and which tones are available for the
second, third and fourth stages.
Example
S4 Dip Switch -
Shown Set for Tone 1
(All switches OFF)
See Quick Start Guide (beginning on page 6) for set-up instructions and functions.
INSTRUCTION SHEET
FOR BUL. 855H
RECORDABLE HORN FRAME E
See PCB layouts on sheet 5 for details.
M4
20 lb-in
(2.2 N
•
m)
(4 places)
Remove 4 screws on rear of unit for access to
power connections, programming functions, and
stage selection connections.
Re-torque as indicated after set-up to maintain
ingress rating.
Remove
Remove
Optional
LED Beacon
4.5 lb-in
(0.5 N
•
m)
(4 places)
