Rockford Fosgate OEQ2 HIGH, Руководство по установке и эксплуатации

Страница: 9 / 40

M
OUNTING
L
OCATION
The mounting location for the OEQ
2
should allow easy access to the
controls for making necessary adjustments. The OEQ
2
will most likely be
adjusted only at the time of installation and will not need further
adjustment unless changes to the audio system are performed. To ensure
optimum performance, care should be taken when mounting the equal-
izer in the following locations:
Engine Compartment
Mounting the OEQ
2
in the engine compartment will void your warranty.
The only thing that should be mounted in the engine compartment is that
big metal thing that makes the vehicle go fast.
Passenger Compartment Mounting
Mounting the equalizer in the passenger compartment will provide easy
access for making adjustments by ear. Select an area which is free from
excessive dirt or dust. If mounting under the seat, be sure the OEQ
2
will
avoid misadjustment from driver or passenger seat movement.
Trunk Mounting
Mounting the equalizer in the trunk will provide easy access for making
adjustments with an RTA (Real Time Analyzer) and pink noise. Select an
area which will avoid possible damage or misadjustment from loading
and unloading items such as groceries, golf clubs and packages from the
trunk.
– 6 –
W
I R I N G T H E
S
Y S T E M
For safety, disconnect the negative lead from the car battery prior to
beginning the installation.
1. Wire the Power Connector
The B+ lead should be connected to a source of non-switched 12 volts
DC. Prepare a length of cable from the co12V by stripping 3/8"
of insulation from the end of the wire. Insert the bared wire into the B+
terminal of the power connector and fasten the screw.
NOTE: The B+ lead of the audio system MUST be fused 18" or less from
the vehicle's battery. Install a fuseholder, along with the necessary
fuse, under the hood. Connections should be water tight.
The REM lead should be connected to the remote turn-on or power
antenna output from the source unit. Prepare a length of cable from the
source of switched voltage by stripping 3/8" of insulation from the end