Rockford Fosgate OEQ2 HIGH, Руководство по установке и эксплуатации

Страница: 7 / 40

– 4 –
8. Output Level Attenuators – The Output Level Attenuators are
used to cut the output level for matching the input of the amplifier.
They can be adjusted to levels ranging from a minimum ratio of
1:0 (no output) to a maximum ratio of 1:1.
9. Boost/Cut Controls – These controls provide up to 12dB of boost
or cut to the selected frequency.
10. Frequency Warp Controls – These controls provide up to an
octave range (1/2 octave up and 1/2 octave down) from the center
frequency to pinpoint “dips” and “peaks”.
11. LED Level Indicators – The level indicators monitor the input level
of the OEQ
2
. The indicators utilize green, amber and red LEDs to
represent low, high and maximum signal level.
12. Power Connector – The power connector provides a convenient
connection for ground, power and remote. The connector uses
“screw lock” terminals to secure the power wires and is remov-
able for quick disconnects.
13. B+ Fuse – The B+ fuse protects the power supply and battery from
short circuits and power failures.
14. DGND/AGND Jumper – This jumper is used for troubleshooting
systems which may exhibit noise due to ground loops or lack of
ground potential.
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
0
+
12
-12
L
E
F
T
R
I
G
H
T
DGND
CHS
AGND
5
11
14
13
5
8
8
9
9
10