Rock Shox BoXXer R2C2, Техническое руководство

Страница: 10 / 21

GEN.0000000003185 REV A 10
bo
XX
er r2C2 TeChniCal Manual
lower leg reMoval (ConTinued)
Use a 5 mm hex wrench to loosen the spring shaft 5.
bolts three to four turns.
Use a plastic mallet to firmly strike the spring shaft 6.
bolt to free the spring shaft from its press-fit to the
lower leg. Remove the spring shaft bolt and rebound
bolt/adjuster assembly completely.
Allow the oil to drain. 7.
if oil doesn’t drain from one or both sides, the press
fit(s) may not be completely released. re-install the
shaft bolt(s) two to three turns and strike it again.
Remove the lower leg from the fork by firmly pulling 8.
each upper tube out of the lower leg assembly.
do not hit the brake arch with any tool when
removing the lower leg as this could damage the
fork. if an upper tube does not slide out of the lower
leg, the press fit on that side may not be completely
released. re-install the shaft bolt two to three turns
and strike it again.
Allow any remaining oil in the lower leg to drain into 9.
the oil pan.
Spray isopropyl alcohol onto the upper tubes and 10.
clean with a lint free rag.
Inspect the upper tubes for damage. 11.
damage such as scratches, chips or wear marks on
the surface of the upper tube can cause oil to leak
during use and allow dirt and debris to contaminate
the internals of the fork. damaged upper tubes
should be replaced.
6
8
5