Rock Shox BoXXer R2C2, Техническое руководство

Страница: 20 / 21

GEN.0000000003185 REV A 20
bo
XX
er r2C2 TeChniCal Manual
forK insTallaTion (ConTinued)
4
Use a 4 mm hex wrench to torque the four lower 4.
crown bolts in an alternating fashion to
7.3 N·m (65 in-lb). Torque the two upper crown bolts
to 7.3 N·m (65 in-lb).
Re-install the brake according to the brake 5.
manufacturer’s instructions. Fasten the brake hose
to the brake hose guides on the fork’s lower leg.
Position your wheel in the lower leg dropouts. The 6.
hub should seat firmly in the dropouts. Be sure to
position the disc brake rotor in the caliper. verify
that neither the rotor, hub, nor rotor bolts interfere
with the lower legs. If you are unfamiliar with
adjusting your disc brakes, see your brake
manufacturer’s instructions.
Slide the externally threaded end of the maxle dH 7.
through the drive side of the hub, until it engages the
threads of the lower leg dropout. Use a 6 mm hex
wrench to turn the drive side axle bolt and tighten the
axle into the dropout. Torque to 5.7 N·m (50 in-lb).
Use a 6 mm hex wrench to turn the non-drive side 8.
axle bolt clockwise until you hear or feel 8 clicks or
you reach a torque value of 3.4 N·m (30 in-lb).
Re-check that all damping adjusters are at their 9.
original positions (documented in the table in the
“Getting Started” section), or refer to the
BoXXer R2c2 Tuning Guide to aid in tuning
adjustments for the rider.
5
7 8