Chapter 2
TECHNICAL INFORMATIONS
-
5
-
English
C22
4151
100.fm
ID
M
2.2.
ACCESSOIRES (OPTIONAL)
The following accessories, which are intended to en-
hance the machine performance and versatility, are
available from the Manufacturer.
–
Automatic cutting device
: it cuts the film automat-
ically at the cycle end
–
Side guide masts (increased)
: permit wrapping
heights up to 2400, 2800 mm and 3000 mm.
–
Double sensing arm
: suitable for wrapping pallets
in cases where the product sticks out from the edge
of the pallet unevenly.
–
Sensing arm with a larger wheel (ø390 mm)
: suit-
able for wrapping pallets whose product is not com-
pact.
–
Remote control
: to adjust a number of parameters
while the machine is running.
–
Film breakage sensor
: detects broken film and
empty reel.
–
Non-stain wheels
: wheels made of a material that
reduces stain formation on the floor.
–
Reel holding carriage "FRD for net"
: carriage for
winding the pallet with a net film.
2.3.
MODES OF WRAPPING
The wrapping can occur in the following
modes.
1)
"Upward wrap" on a pallet
(a)
and
"downward wrap" on the next pallet
(b)
.
2)
"Upward and downward wrap"; it is
performed on the same pallet to
achieve proper balance.
The "wrap pitch" depends on the
spool carriage speed.
Wrapping is generally characterised by
a number of horizontal wraps from the
base to the upper end of the pallet.
Wrapping types are defined by the
quantity of wraps set by the operator on
the control panel.
The illustration displays the wrapping
types.
A)
Single wrap
B)
Double wrap.
The machine can also perform an
intermediate reinforcement (C) wrap
equal to the lower wrap. To perform
this wrap, the operator must set the
height from the ground level on the
control panel.
IDM-24126600200.tif
a
b
1
2
IDM-24126600600.tif
A
B
C
