Chapter 6
INFORMATION ON USE
-
24
-
English
C62
4151
100.fm
ID
M
6.6.
DESCRIPTION OF (YELLOW) BUTTONS FOR PARAMETER SETTING
4a) "Feeding speed" key
: to set the
machine feeding speed.
4b) "Film pre-stretch/stretch" key
:
to achieve the desired film pre-
stretch ratio (“
PFS
”-, and “
FS
”-
type spool carriages) and film
stretch ratio (“
FR
”-type spool
carriage).
4c) "Bottom wraps" button
: to set
the number of bottom end wraps
on the pallet.
4d) "Top wraps" button
: to set the
number of top end wraps on the
pallet.
4e) "Carriage upward speed" key
: to
set the spool carriage upward
speed.
4f) "Carriage downward speed"
key
: to set the spool carriage
downward speed.
4g) "Output data"
: to display the following data.
– D1 cycle partial counter.
– D2 cycle total counter 1000÷999000.
– D3 cycle total counter 0÷999.
– D4 battery voltage.
– SET to reset the cycle partial counter.
To reset, press keys simultaneously when the
wordings "SET" appears. The wordings "RES"
will appear next to confirm that the operation has
been successfully completed.
4h) "Film tensioning" key (PFS-type spool
carriage)
: to adjust the wrapping tension
according to the various types of load.
6.7.
DESCRIPTION OF (GREEN) BUTTONS FOR CYCLE SELECTION
5a) "F1" key
: to select the wrapping
cycle of a very large load (e.g. a
container).
5b) "Reinforcement Wrap" key
: to set
the distance between the
intermediate wrap and the bottom of
the spool carriage, if necessary.
The number of wrapping turns is the
same as the lower wrap.
5c) "Start from ground level" key
: to
make the wrap start from an offset
from the ground level.
5d) "Photocell/Altimeter" delay key
:
has two functions, hold down for
three seconds to change the
function.
IDM-24126601700.tif
B
4a 4c
4f
4g
4h
4e
4d
4b
A
IDM-24126601700.tif
5a
5b
5c
5d
5e
5f
