45
Message
Displayed
Probable Cause/Event
Corrective/User Action
CAUTION
– Remove battery fuse before
lifting the mower
-
The Robomow has driven onto an
obstacle, raising the front end. Remove
or exclude this object from the mowing
area.
-
The Robomow is being used on a slope
too steep for safe mowing. Exclude this
from the mowing area.
-
High grass is preventing the front wheel
from fully riding on the ground. Raise
the cutting height.
Frnt wheel prob
-
The Front Wheel has left the ground for
more than 8 – 10 seconds.
-
The ground contains large holes or
indentions where the front wheel can
drop into when passing across. Fill
these areas with dirt and level off.
High temperature
waiting…
-
Robomow is charged through the Base
Station and the ambience temperature is out
of range (above 158ºF / 70ºC);
-
Do not do anything, the charging is
stopped and Robomow is waiting for
temperature to change back to the
allowed range; if temperature stays out
of the range for more than 12 hours, the
message is changed to
‘High temp.
Press GO
’.
Insert fuse
for charging
-
Robomow is connected to charging without a
battery fuse
-
Disconnect Robomow from charging,
insert the battery fuse and reconnect to
charging.
Keep charging
if not used
-
Message is displayed every time the power
supply is disconnected.
-
Displayed when the mower isn’t in operation
and not connected to the charging for a long
time.
-
Press any key to change the display
back.
-
Send the mower back to the Base
Station for charging / connect the power
supply or continue in operation.
Key pressed
-
One of the operating panel buttons is
constantly pressed.
-
Press ‘
GO’
to confirm the message and
to continue in operation. The message
is displayed to inform the user about
the problem, but will not prevent the
operation.
Keys locked
-
Child lock feature has been activated
-
Press the
Up
arrow key and then
press the
‘STOP’
button.
Child lock can be deactivated under the
‘
Settings
’ menu.
-
Mower is searching for the Base Station but
the battery voltage is too low to continue the
searching process.
-
Drive the mower manually using the
remote control or carry it by hand for
charging in the Base Station.
Low battery
-
Robomow has skipped the last start time due
to low battery voltage
-
Confirm there is enough time between
the two adjacent departures so the
battery can be charged prior the
scheduled operation (min 16 hours
between operations)
Low temperature
waiting…
-
Robomow is charged through the Base
Station and the ambience temperature is out
of range (below 32ºF / 0ºC);
-
Do not do anything, the charging is
stopped and Robomow is waiting for
temperature to change back to the
allowed range; if temperature stays out
of the range for more than 12 hours, the
message is changed to ‘
Low temp.
Press GO’
.
Mow overheat
cooling, wait…
-
The mowing motor has been working under
a severe load for too long of a time.
-
There is no need to do anything –
Robomow will renew automatically the
operation, as the mowing motor will
cool down.