37
2.2.5 Language
Allows the user the option of viewing the LCD text in several different language versions.
2.2.6 ECO
Mode
The ECO (Economic) mode feature enables operating Robomow using minimum energy
required to cut the grass and maintain the lawn. The ECO mode default is set to 'on'.
Operation in ECO mode reduces Robomow noise level during operation and allows longer
operation time. It is recommended to use the ECO mode only in zones with Base Station,
where mowing is more frequent and a shorter part of the grass is cut. If Robomow detects
high grass it will automatically increase the power of the mowing motor to enable cutting
higher grass
.
2.2.7 Signal
type
In some circumstances there may be interference to the wire signal caused by other wire signal
activated in adjacent lawn (neighbor that use robotic lawnmower) or by any other appliance
using similar
frequency. In case of signal interference, you may see one of the following symptoms (usually
close to
the neighbor lawn):
a.
Robomow is widely swinging when driving along the wire;
b.
Robomow changes direction without reaching the wire;
c.
Robomow crosses the wire outside the designated area;
d.
'Start inside' message is displayed although Robomow is inside the designated area and
the perimeter wire is connected in the right polarity;
If your mower faced one of the above symptoms, to change the signal type call to service
2.2.8
Blade Replaced
Choose this option after replacing the blade to restart the reminder counter. A reminder to replace
the blade again will be displayed after the next 200 hours of operation. Blade is easy to replace,
refer to section 5.5.
2.2.9 Wire
Position
Allows user to test the wire position in
‘Edge’
mode while the mowing motors are switched off to
prevent any damage to the perimeter wire after the initial setup of the wire is completed.
2.2.10 Delay
operation
This option allows the user to press GO but delay the operation starting time. It is useful when you
want to start the operation later in the day when the grass is dry and not early in the morning
when the grass is wet (and you have to leave for work).
To use this option, follow the steps below:
-
Set the ‘Delay operation’ to X hours (choose between 1,2,3…or up to 8 hours);
-
Switch on the Perimeter Switch (It is operated for 12 hours) and place the mower inside the
lawn towards the perimeter wire;
-
Pressing ‘STOP’ then ‘GO’ (while holding the ‘STOP’ button) will change the display to ‘Press
GO again to skip edge’ and at the end of the warming up process, the mower will stay in place
with a message ‘Operation delayed – wait…’
-
The mower will start the operation after X hours (as set in the ‘Delay operation’ menu) from the
‘GO’ pressing.
Eco mode
Press GO
Eco mode
on
Press GO
Eco mode off
Confirm