©
2018 DJI All Rights Reserved
13
b. Change the pairing mode of the Camera Transmission Module to "Manual pairing" or "Auto pairing" to allow a user to freely
select the connection method for the Camera Transmission module when debugging. The Referee System is set to "Auto pairing"
by default. After this parameter is set, you can press and hold the OK key to save it. The setting remains valid even after the robot
is powered on again. For details about the two modes, refer to "Camera Transmission Module Instructions". On the function page
of the Main Control Module, change the pairing mode to "Manual pairing", as shown below:
3. Setting competition-specific parameters
On the interaction interface, you can set the parameters of a robot, including its maximum HP, maximum speed and maximum heat.
The following example shows how to set a robot's power limit as unlimited on the function page of the Main Control Module:
Press the PgDn
key 3 times
Press the PgDn
key 2 times
Press the PgDn
key 1 time
Press and hold
the OK key
System
Read
Game
Debug
Setup
Version
Setup
Option
Ignore
Ignore
Function
Cur Offline
All Offline
Enable Mask
Offline Mode
Auto Camera Chan
Offline Mode
Auto Camera Chan
Press the OK key
System
Read
Game
Debug
Setup
Version
Setup
Option
Press the OK key
Ignore
Ignore
Function
Cur Offline
All Offline
Enable Mask
Press the OK key
Offline Mode
Auto Camera Chan
Save Success
Press the PgDn
key 2 times
System
Read
Game
Debug
Setup
Version
Setup
Option
Reset HP
Set max. HP
Set max. power
Set the max. launching speed of a
17mm projectile
Set the max. launching speed of a
42mm projectile
Reset
MaxHP
MaxPower
MaxSpeed0
MaxSpeed1
Reset
MaxHP
MaxPower
MaxSpeed0
MaxSpeed1
HP
Setup
Setup
Setup
Setup
HP
Setup
Setup
Setup
Setup
Press the OK key
Set MaxPower Success
Press the OK key
System
Read
Game
Debug
Setup
Version
Setup
Option
Set the max. heat of a 17mm projectile
Set the max. heat of a 42mm projectile
MaxPOWER: 80
MaxPOWER: 120
MaxPOWER: Unlimited
MaxPower
MaxSpeed0
MaxSpeed1
MaxHeat0
MaxHeat1
Setup
Setup
Setup
Setup
Setup
Press the OK key
Press the PgDn
key 2 times