Robland E2800, Руководство пользователя

Страница: 4 / 65

E300 / E 2800 V0913
3
English Deutsch
Important instructions when ordering
spare parts
Always mention the following items on your order :
Type of machine
Serial number from manual
Part number and quantity
Your reference and correct phone and fax number
For your saFety and the prolonged use oF your MaChIne: use only
orIgInal parts oF roBland !!!
Safety and maintenance instructions
Woodworking with machinery is a pleasant job that will give you a lot of satisfaction. Nevertheless,
working with a machine requires constant attention and care. Therefore, for your own safety, pay
attention to the instructions summarised in this chapter.
The machine can only be used safely if the operator strictly follows the operating and safety
instructions.
It is absolutely essential to read this manual before using the machine so you know how the
machine works and what its limitations are.
Always make sure that all safety devices are fitted to the machine and that the machine is
connected to a dust extraction system.
Also provide sufficient space around the machine and good lighting in the workshop.
When changing the tools or when doing a maintenance job, the machine must always be
disconnected from its power supply.
Knives and tools which are not correctly sharpened or are in bad condition not only diminish the
quality of the work, but also increase the risk of accidents.
Always wear suitable clothing. Loose or torn clothes are very dangerous.
Keep children away from the machine and the workshop.
To avoid damaging your hearing, the wearing of ear protection is mandatory.
When cutting narrow pieces always use a push stick. When damaged replace the push stick at once.
When cutting round work-pieces, always make sure the work-piece is secured against slipping.
Always use adapted jigs and templates and saw blades adapted to the work being carried out.
Carefully read the recommendations for adjusting the brake of the main saw brake motor.
Make sure all periodic maintenance work is done on time. These maintenance works may only
be carried out with the machine disconnected from the main power supply line thus rendering it
impossible to start the machine involuntarily.
Read carefully the instructions for cleaning the machine, clean only with the machine disconnected
from it’s power supply line.
Test on a weekly basis the following electrical components: emergency stops buttons, the safety
switches on the saw unit and test if the machine can be started-up with open doors.
Test on a weekly basis if the run down time of the saw motor brake does not exceed the 10 seconds.
Please read the noise emission values in the manual.