Robland E2800, Руководство пользователя

Страница: 21 / 65

20
V0913 E 300 / E 2800
English Deutsch
Calibration of the scale on the parallel
fence
(Fig.21)
Each time a new sawblade is fitted the parallel fence scale has to be calibrated to the new
sawblade.
By cutting a sample and measuring its exact length, the scale can be adjusted so that the exact
measure corresponds with the front side of the fence.
After the screw (1) has been loosened the scale can be adjusted. To avoid the fence contacting the
sawblade while it is revolving, the stopring (2) has to be adjusted.
Slide the fence to about 10 mm from the sawblade.
Now slide the stopring (2) across the round guide bar (3) until it comes up against the
casting of the fence. Tighten the lock screw on the stop ring.
Sawguard
(Fig.22)
For safety and health reasons it is highly recommended to connect the machine and the saw guard to
a dust extractor system.
Both outlets on the machine (dia.100 mm) and on the saw guard (dia.25 mm) need to be connected,
and the dust extractor should be powerfull enough to obtain an airflow of at least 20 m/sec.,
measured at the outlet on the machine.
The guard has to be adjusted in such a way that both main and scoring sawblade are covered, and
should be adjusted in height so that the workpiece can slide under the guard.
Always ensure the locking handle (2) is well tightened.
Fig.22 Fig.21
1
2
3