Robe StageQube 324, Руководство пользователя

Страница: 5 / 19

5
Only operate the fixture after having checked that the housing is firmly closed and all screws are tightly faste -
ned.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
if this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, burns due to ultraviolet radiation, lamp explosion, crash etc.
2.2 Structural requirements
Structural Requirements to StageQube and Accessories (BlindQube– Without LEDs, BlindQube-Expo,
StageQube- Floor Unit)
the modules are adequately capable of bearing loads, if the following conditions are observed:
in general: taper pins, property class 5.6.
after driving in of the taper pins, they shall be fixed with cotter pins.
2.2.1.0 StageQube, BlindQube Without LEDs, BlindQube- Expo, StageQube- Floor Unit
2.2.1.1 Unsupported Type Combined with StageQube- Floor Unit (max. 5 modules)
- diagonal tubes as sectional tubes RR RR 50x2 AlMgSi 0,5 F22.
- in case of possible impact with a person, a ballast with a weight of 50 kg shall be placed
between the bottom ends of each gap of the erected system.
- In case impacts can be excluded, ballast with a weight of 20 kg are required.
2.2.1.2 Suspended Type (max. 12 modules)
- the annular lug must have been approved to bear loads of 350 kg by the manufacturer.
- all suspension points shall be designed for load actions of .74 kn.
- dynamic lifting forces and downward motions as a result of elastic materials shall be
considered for the suspension points.
2.2.2.0 BlindQube-Mediaadapter
2.2.2.1 Suspended Type (Without Abutment)
BGVC1 (for passenger traffic) max. 3 modules
DIN 4113 (without passenger traffic) max. 6 modules
- the annular lug must have been approved to bear loads of 330 kg by the manufacturer.
- all suspension points shall be designed for load actions of .65 kn.
- dynamic lifting forces and downward motions as a result of elastic materials shall be
considered for the suspension points.
- max. 45 kg at each Qube at a distance of 47 cm.
- this requires exact static calculation