7
To reduce a hot-spot, pull the lamp in by turning all three screws „A, B, C” clockwise 1/4-turn at a time until the
light is evenly distributed.
If the light is brighter around the edge than it is in the center, or if light output is low, the lamp is too far back in the
reflector. „Push” the lamp out by turning the screws „A, B, C” counterclockwise 1/4-turn at a time the light is bright
and evenly distributed.
4.3 Rigging
DANGER TO LIFE!
Please consider the respective national norms during the installation! The
installation must only be carried out by an authorized dealer!
The moving head is designed for ceiling mounting.
The installation is of the moving head has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
When rigging, derigging or servicing the fixture staying in the area below the installation place, under high working
places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an expert
before taking into operation for the first time and after changes before taking into operation another time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an expert
after every four year in the course of an acceptance test.
The operator has to make sure that safety relating and machine-technical installations are approved by a skilled
person once a year.
The moving head should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all installation
material and the projector. If you lack these qualifications, do not attempt the installation yourself.Improper
installation can result in bodily injury and (or) damage to property.
The moving head has to be installed out of the reach of people.
Caution: Moving heads may cause severe injuries when crashing down! If you have doubts concerning the safety
of a possible installation, do NOT install the moving head!
Before rigging make sure that the installation structure can hold a minimum point load of 10 times the moving
head’s weight.
Danger of fire !
When installing the device, make sure there is no highly inflammable
material (decoration articles, etc.) in between a distance of min. 0,5 m.
CAUTION!
Make sure that the device is fixed properly! Ensure that
the structure (truss) to which you are attaching the fixtures is secure.
The moving head do not have a power switch.
The AC mains supply must be fitted with a circuit breaker to isolate
the fixture from the mains during service ,lamp replacement or when not in use.