Robe Color Spot 1200 AT, Руководство пользователя

Страница: 32 / 43

32
Time mode --- Pan and tilt will move with different speeds and they will come at the same
time to end point (pan and tilt sets its optimal speed).
Speed Mode --- Pan and tilt will move with the same speed as adjusted by the channel 6
(Pan/Tilt speed).E.g. pan will come to the end point and wait for tilt,which has longer track.
Active Blackout while: --- Use this function if you wish to close the light output during effect changes.
Pan/Tilt Moving --- This function closes the light output during pan/tilt changes.
Colour Wheel Moving --- This function closes the light output during colour changes.
Gobo Wheels Moving --- This function closes the light output during gobo wheel 1/gobo
wheel 2 changes.
IR Sensor --- Select this function to switch on/off infra-red remote control.
Init Effect Positions --- Select this function to set all effects to the desired positions.After switching the fixture on
(if DMX is not connected),all effects will move to this init positions.
Note:If you operate 24 channels pre-setting (Mode 1) and you adjust DMX values for channels which are
not included in this mode,you will not be able to change these effects from the controller !
For example:You operate the Mode 1 and in "Init Effect Positions" menu is adjusted CMY Colour Macro =150,this
value shoud be 0 or you will not abble to control cyan,magenta and yellow because these effects are used in CMY
macros and the macros have a priority.
Default Settings --- Select this option to reset all fixture personalities to the default values.
8.4 Lamp On/Off
Use this option in order to switch on/off the lamp.It is also important to note, that the lamp is cold restrike type,
that means, that it have to be cold before striking.
8.5 Test sequences
Use this menu to to run a special demo-test sequences without an external controller, which will show you some
possibilities of using COLORSPOT 1200 AT.
Mode 1 --- This mode is suitable for projections on the wall, ceiling or ground without any head
movement.
Mode 2 --- This mode uses all COLORSPOT 1200 AT functions including pan/tilt movement and
therefore is good for a complete introduction of the fixture.
8.6 Manual mode
Presetted Effects --- Select this menu to call up presetted positions of channel effects.
Manual Effect control --- Select this menu to control channels by control elements on the control board.
8.7 Stand-alone setting
Use this menu to set options for stand-alone mode as a selection of the playing program,programming and
modifying current programs.
Music Trigger --- Select this function to enable the sound control of the running programs via the
built-in microphone.
Presetting Playback --- This function allows you to select the program which will be played in the
stand-alone mode after switching the fixture on.Selected program will be played
continuously in a loop.
Disabled --- The option disables "Presetting playback" function.
Test Program --- The option will start built-in test program.
Program 1 --- The option will start created program No.1
Program 2 --- The option will start created program No. 2
Program 3 --- The option will start created program No. 3
Note:If the fixture operates in the controller mode ( DMX controller is connected) and any program from this menu
is selected ,in this case the fixture will not respond to the DMX controller after switching on and will play selected
program.
Playing program --- Select this menu to run a bilt-in program or the 3 freely-programmable programs