14
4.8 Ethernet connection
The fixtures on a data link are connected to the Ethernet with Art-Net communication protocol.The controlling
software from PC (or lighting console) has to supported Art-Net protocol.
Art-Net communication protocol is a 10 Base T Ethernet protocol based on the TCP/IP.Its purpose is to allow
transfer of large amounts of DMX 512 data over a wide area using standard network technology.
The COLORSPOT 1200 AT is equipped with 8-pin RJ- 45 socket for Ethernet input.Use a network cable category
5 (with four "twisted" wire pairs) and standard RJ-45 plugs in order to connect the fixture to the network.
RJ-45 socket (front view):
RJ-45 plug (front view):
1- TD+
5- Not connected
2- TD-
6- RX-
3- RX+
7- Not connected
4- Not connected
8- Not connected
Patch cables that connect fixtures to the hubs or LAN sockets are wired 1:1,that is,pins with the same numbers
are connected together:
1-1
2-2
3-3
4-4
5-5
6-6
7-7
8-8
If only the fixture and the computer are to be interconnected,no hubs or other active components are needed.A
cross-cable has to be used:
1-3
2-6
3-1
4-8
5-7
6-2
7-5
8-4
Ethernet connection
Connect the Ethernet-inputs of all fixtures in the fixture chain with the network.
Options "Enable Ethernet" has to be selected from "Set Ethernet Mode" menu on the fixture.
Set IP address (002.xxx.xxx.xxx / 010.xxx.xxx.xxx) and the Universe.
Example:
(DMX address=49)
(DMX address=25)
(DMX address=1)
IP addres=002.168.002.003
IP addres=002.168.002.002
IP addres=002.168.002.001
Universe=1
Universe=1
Universe=1
A control PC setting: IP address: 002.xxx.xxx.xxx / 010.xxx.xxx.xxx (Different from fixture IP addresses)
NET mask: 255.0.0.0
Содержание Color Spot 1200 AT
Страница 1: ...1 ...
Страница 40: ...40 Beam path Lamp MSR 1200 SA ...
Страница 41: ...41 ...
Страница 43: ...43 ...
