ROBBE AIR TRAINER 140 ARF, Инструкция по сборке и эксплуатации, Страница: 8 / 38

8
Building and Operating Instructions - Air Trainer 140 ARF
No. 2581
3. Setting the programming point (value):
You will hear a looped sequence of different sounds. Move the throttle stick to "full-throttle" in order to set the value. You will then hear a
special "1515" sound which confirms and stores your selection.
(Moving the throttle stick to full-throttle returns you to Step 2, and you can then select the next point. Moving the throttle stick within two
seconds quits programming mode.)
Programming points “Beep” (1 brief beep) “Beep-Beep” (2 brief beeps) “Beep-Beep-Beep” (3 brief beeps)
Brake Off On
Battery type Lipo NiMH
Cut-off Soft-cut Cut-off
Cut-off threshold Low Medium High
Start mode Normal Soft Super-soft
Timing
Low Medium High
4. End of programming
There are two methods of quitting programming mode:
1. In Step 3 after the special “1515” beep move the throttle stick
to the "fully back" position within two seconds.
2. In Step 2 after the “Beep-----Beep-----” sound (e.g. Point #8),
move the throttle stick to the "fully back" position within three
seconds.
1. Start programming mode
1) Switch transmitter on, move throttle stick to full-throttle,
connect battery to speed controller.
2) Wait two seconds: you should hear a “beep- beep-”
sound.
3) Wait a further five seconds; you should hear a special
“56712” sound. This confirms the start of programming
mode.
2. Select the programming point:
When programming mode commences, you will hear a looped sequence of eight sounds. Moving the throttle stick to the neutral
position within three seconds of hearing a particular sound selects the corresponding point.
1. “beep”
Brake (1 brief beep)
2. “beep-beep-” Battery type (2 brief beeps)
3. “beep-beep-beep-” Low voltage (3 brief beeps)
4. “beep-beep-beep-beep-” Cut-off voltage (4 brief beeps)
5. “beep-----” Start mode (1 long beep)
6. “beep-----beep-” Timing (1 long, 1 brief)
7. “beep-----beep-beep-” Reset to default (1 long, 2 brief)
8. “beep-----beep-----” Quit (2 long beeps)
Programming the speed controller using the transmitter (four steps):
Note: Please ensure that the throttle stick is at the Idle position (fully back), and that throttle travel is set to 100%.