19
R
O
-M
A
N
®
RO-MAN Options
Pressure Gauge
There are two reasons for fitting a pressure gauge:
1. To read the water pressure in order to check whether it is within specification. System pressure is very
important too little pressure will make the production rate very slow and too much pressure will make the
seals fail. Low pressure will make the TDS higher e.g. a system running at 65 psi may have a TDS of 5
while the same system running at 40psi could have a reading as high as 15.
2. To work out when the sediment filters are blocked.
Deionisation (DI)
Deionisation is used to polish the water making it 100% pure. TDS reading should be near zero if using a
DI unit.
Inline TDS Meter
TDS (Total Dissolved Solids) meters are used to work out how well the reverse osmosis system is running.
By measuring the feed water TDS and then measuring the output you can work out the rejection rate.
92% Rejection is OK
95% Rejection is GOOD
98%+ Rejection is EXCELLENT.
Waste Clamp
This can be bought from
www.ro-man.com
and can be used to attach the waste pipe from the RO system
to a 36mm domestic plastic waste pipe.
RO-MAN Integrated Pumpbox
We have developed a pump box that will increase the water pressure that drives the membrane. This
pump box contains a pump, high pressure switch, to protect and help extend the life of the pump. The
pump box also has a solenoid valve to stop water going through the system when the pump is not working.
Manufacturer Information
Name: RO-MAN Water Filtation
Address: 7 Creagh Road
Telephone:
01823698813
Toomebridge
ANTRIM
Email:
BT41 3SE
Spares and accessories are available though our website: www.ro-man.com
