11
R
O
-M
A
N
®
Fitting the Pipes
The Push Fit Connectors are opened by pushing down on the collet ring and pulling the hose at the same
time. If you prefer you can use a pair of pliers, a small
spanner or any tool that can apply pressure on both side of
the quick connect collet.
A. Red Pipe: Connects the water supply connector
After cutting the red pipe to a suitable length connect it to the
red capped inlet of your Sediment Filter housing found at the
top right of the RO unit and marked with an up arrow and the word “IN”. Do NOT turn the water on yet!
B. Blue Pipe: Connects y fitting to the sink top faucet
This can be connected to the outlet of the DI Unit and the other end to your point of use. Bear in mind that
you will have to discard the first 2 gallons from this pipe.
C. Green Pipe: Connects to the drain saddle
One end of this to be attached to a suitable waste water discharge point, typically this will be a 36mm white
plastic domestic pipe. Should this be the case a 6mm hole drilled into the top of the pipe will accept the RO
system waste pipe and can be sealed with silicone. An alternative is to use the same pipe as the washing
machine. The other end should be run to the vicinity of the CCB filter housing but do not cut this yet as it
will eventually have to be connected to the membrane housing.
D. Blue Pipe: Connects Y fitting to the storage tank.
Blue Pipe
Collet
Tube
JG Fitting
Red Pipe
Green Pipe
Blue Pipe
