Important Note:
Two people will be needed for completion of step #6.
Move pallet to area where lift will be installed prior to opening. Remove the
outer bands.
1. Remove the cardboard enclosure on the pallet by removing the screws at
the bottom and lifting off the enclosure.
2. Carefully cut black bands around components. Do not cut tie wraps on
mast until step #7.
3. Remove the housing cover, accessory box, and chair assembly. Remove
plastic wrap from housing cover.
4. Remove the base assembly from the pallet and insert into mounting
sleeve/anchor on pool deck.
5. Remove 2 bolts and lock washers from base assembly. Place housing cover
over base unit and line up holes in cover with holes on base assembly.
6. Position mast assembly onto housing cover and attach with bolts and lock
washers. Fully tighten with 3/4” socket wrench. This step requires one
person to hold the mast assembly while a second person secures the bolts.
Wiggle the mast to make sure the connection is secure. Slide attachment
cover down to cover bolts.
7. Cut the tie bands around mast (WARNING! arms will drop, so be careful
they are adequately supported before cutting bands).
8. Extend arm assembly and rest chair support arm on ground; use cardboard
or similar material under chair support arm to prevent finish damage.
9. Cut and uncoil actuator cable at bottom of mast.
10. Run actuator cable to console bracket and insert into receptacle #1 on the
control box.
11. Attach actuator to actuator arm using hardware (2 3/4” bolt, nut and 2
plastic spacers) connected to actuator. Place plastic spacers on either side of
actuator on inside of actuator arm. See section detail in diagram # on pg. 7).
12. Remove and unwrap hand control from accessory carton. Insert connector
into large receptacle on control unit.
13. Attach battery to control unit mounted on console.
14. Press either the up or down button to activate the lifting motion. Raise lift
to its highest position.
15. Check the side to side controls for proper operation.
16. Return lift to forward position away from pool.
17. Attach chair assembly to chair support arm with lock pin into the
appropriate hole. To facilitate storage, chair can be attached facing inward,
which will require less space.
14
Please call RehaMed International at 800-577-4424
if you have any problems or questions with assembly.
