RMG ERZ2000-NG, Руководство по эксплуатации, Страница: 106 / 454

2 Introduction
Manual ERZ 2000-NG · EN07 · 2019, May 13th
96
There is an additional option to connect GPS reception modules of any manufacturer
to the COM 5 (modem) interface. The ERZ2000-NG recognizes the following proto-
cols:
- NMEA 0183
- Meinberg standard
- SAT standard
- Uni Erlangen
- ABB SPA
- Computime and RACAL.
A reference time can also be synchronized. This can be parameterized with coordi-
nates
KC51 Reference hour , KC52 Reference minute and KC53 Reference sec-
ond . The process is triggered via a contact input which can be selected with coordi-
nate KC 21 Source time contact .
Timeserver network
If a time server is known, synchronization can take place via the network.
The following must be observed:
The IP address of the time server must be entered in coordinate
KC40 Time server
37/123 , e.g. 192.53.103.104, corresponding to the internet address ptbtime2.ptb.de
of the PTB time server. The IP address can be determined by pinging
ptbtime2.ptb.de. The protocol of the time server is adjusted in
KC41 Time serv. pro-
tocol , e.g. connection type "UDP" of the PTB time server or "TCP".
The IP address of the local gateway, e.g. 192.168.20.254 of the standard gateway of
RMG Beindersheim can be determined with ipconfig. If an internet address is entered
in
KC40 server Port 37/123
,
a domain name service must be activated in order to
implement a conversion to an IP address. Please select Ethernet connection 1 or 2 in
coordinate
KC42 Network interface , depending on your choice (see
chapter 3.1.4
Data interfaces
).
The IP addresses for the Domain Name Service, i.e. DNS of the telecom are found in
menu
IA TCP/IP network.
Note
After a change of network settings, the network of the ERZ2000-NG must be
switched off and on again for the settings to take effect.