RKC INSTRUMENT MA900 Series, Инструкция по эксплуатации

Страница: 12 / 22

IMR01H01-E4 12
5.6 Setting Procedure
5.6.1 Usual setting (Setting for each channel)
Some examples of changing the set value (SV) are described in the following. The same setting procedure applies when other
parameters are also set.
!"
When the SV is changed
When CH1 set value (SV) of the control area 1 is change from 0
°
C to 300
°
C:
1. Press the SET key in PV/SV monitor
mode state to transfer to SV setting &
CT monitor mode.
2. Press the <R/S key to light brightly
the hundreds digit. The brightly lit
digit indicates which digit can be
set.
Every time the <R/S key is pressed,
the brightly lit digit moves as follows.
3. Press the UP key to change to 3 .
4. Press the SET key to register the
value thus set. The display changes
to the next parameter (Memory area
transfer display).
The following is also available when changing the set
value.
!"
Set value increase (When 199
°
C is changed to 200
°
C):
1. Press the <R/S key to light brightly the least significant digit.
2. Press the UP key to change to 0 .
The display changes to 200 .
!"
Set value decrease (When 200
°
C is changed to 190
°
C):
1. Press the <R/S key to light brightly the tens digit.
2. Press the DOWN key to change to 9 .
The display changes to 190 .
!"
Minus (-) value setting (When 200
°
C is changed to -100
°
C):
1. Press the <R/S key to light brightly the hundreds digit.
2. Press the DOWN key (three times) to change to -1 .
The display changes to -100
.
!"
When another area set value (SV) is changed without
changing control area
When changing the set value (SV) corresponding to channel 2 in
memory area 3 from 150
°
C to 100
°
C with the memory area set
to memory area 1:
1. Press the SET key in PV/SV monitor
mode state to transfer to SV setting &
CT monitor mode.
2. Press the <R/S key to light brightly
the AREA display. The brightly lit
digit indicates which digit can be
set.
Every time the <R/S key is pressed,
the brightly lit digit moves as follows.
3. Press the UP key to change to 3 .
The SV display shows the channel 1
set value (SV) of the memory area
number 3. Also, the number of AREA
display flashes.
4. Press the CH key to change to 2 .
The SV display shows the channel 2
set value (SV) of the memory area
number 3.
5. Press the DOWN key to change to 0
in the tens digit.
6. Press the SET key to register the
value thus set. The display changes
to the next parameter (Memory area
transfer display).
The changed set value is registered by pressing the SET
key or also at the time when any of the following key
operations is performed.
•
When the channel number is changed by the CH key
•
When the memory area number is changed
PV CH
SV AREA
PV CH
SV AREA
Bright lighting
PV CH
SV AREA
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV
SV
PV CH
SV AREA
PV CH
SV AREA
PV CH
SV AREA
PV CH
SV AREA
Flashing
AREA SV
PV CH
SV AREA
Flashing
PV CH
SV AREA
Flashing
PV CH
SV AREA
Bright lighting
AREA SV