Product Manual | Lynx™ Embedded Sensors LES‑B‑127‑50/125/500/2000
13
INSTALLATION SPECIFICATIONS (
continued
)
3.
Ejector Pin Head Pocket
Machine a pocket for the ejector pin head
in the ejector retainer plate that is equal
to the ejector pin head DIA plus 0.02”
(0,5 mm [
1
at right
]) MIN per side.
Allow clearance above the ejector pin
head. If the part thickness is < 0.05”
(1,5 mm), the clearance should equal 20%
of the part thickness. If the part thickness
is > 0.05” (1,5 mm), the clearance should
equal 0.01” (0,3 mm [
2 i
at right
]).
NOTES
L
Ejector pin head clearance not to
exceed 20% (1/5th) of part thickness
at point of pin/part convergence.
Chamfer the lead‑in edge 45° (
3
at right
)—
refer to the following table for chamfer
length.
CHAMFER LENGTH
Ejector Pin DIA
Chamfer Length
0.04–0.08 (1,0–2,0 mm)
0.01 (0,3 mm)
0.10–0.20 (2,5–5,0 mm)
0.02 (0,4 mm)
0.24–0.40 (6,0–10,0 mm)
0.025 (0,6 mm)
Fit the ejector pin with an H7/g6 standard
fit (
4
at right
).
Counterbore the ejector pin head pocket
into the ejector plate 0.01” (0,3 mm [
5
at
right
]) MIN deep, by ejector pin head DIA +
0.04” (1,0 mm [
6
at right
]).
1
2
3
4
5
6
CLAMP PLATE (TYPICAL) INSTALLATION
CAUTION
a
Transfer pin applications require
guided ejection; failure to comply
may result in damage to or
destruction of components.
1
0.02” (0,5 mm) MIN per side
2
20% part thickness if < 0.05” (1,5 mm), 0.01” (0,3 mm) if part thickness > 0.05” (1,5 mm)
i
3
45° Chamfer, refer to table for chamfer length
4
H7/g6 standard fit
5
0.01” (0,3 mm) MIN
6
ejector pin head DIA + 0.04” (1,0 mm)
Содержание Lynx LES-B-127-125
Страница 2: ...PRINT DATE 08 24 2021 REVISION NO 0 ...
Страница 8: ...Lynx Embedded Sensors LES B 127 50 125 500 2000 Product Manual vi NOTES ...
Страница 58: ...Lynx Embedded Sensors LES B 127 50 125 500 2000 Product Manual 50 NOTES ...
Страница 65: ......
