TF2034901-RG Eng Page 9 of 15 20161017-V1
Lighting Instructions
1
Read instruction before lighting.
2
When you are sure there are no leaks, turn cylinder valve and regulator control valve
on hose to the closed position.
3
Reopen cylinder valve fully.
4
Have a standard match, fireplace match or long-nosed propane lighter lit and ready to
place over the burner.
5
Light the burner from the burner top before opening the gas supply, keeping hands and
face away from open burner.
6
Place lighter over the burner open, then slowly open regulator valve until burner
ignites.
7
Adjust the regulator control valve for desired flame height.
8
When finished using the cooker, turn off gas cylinder valve first. It will take a few
second for the fire to go out and for the propane gas to
“bleed” from the hose and
regulator assembly. After the fire is completely out, turn regulator control valve to the
“OFF” position.
9
To re-light, repeat steps 1
– 8. Always use CAUTION as cooker will be hot.
10 If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and
repeat the lighting procedure.
CAUTION
If burner does not light OR if burner flame is accidentally extinguished, turn knob to OFF, wait 5
minutes, try again. If the burner does not ignite with valve open OR if burner flame goes out after
lighting, gas will continue to flow out of the burner and could accidentally ignite with risk of injury.
Burner Flame Check
Light Burner, rotate knob from HIGH to LOW. You should
see a smaller flame in LOW position than seen on HIGH.
Always check flame prior to each use. The air damper (D)
mounted on the back of your burner helps to control the
amount of primary air that mixes with the LP gas. A blue
flame with little or no yellow flame provides the best heat.
Adjust the air damper by turning it clockwise or
counterclockwise until the desired flame is achieved.
Turning LP Cooker Off
Turn all knobs to OFF position, turn LP tank OFF by
turning hand-wheel clockwise to a full stop.
Hose Assembly and Regulator Check
Cleaning and inspection of pressure regulator and hose assembly
prior to use. If there is evidence of abrasion, wear, cuts or leaks, the
hose assembly must be replaced prior to the appliance being put
into operation. The replacement hose assembly shall be that
specified by the manufacturer.
Cleaning the Burner
CAUTION
Check and clean burner / manifold tube for insect nests. A clogged tube can lead to fire beneath
the appliances.
Spiders’ nests or wasps’ mud inside the burner may cause fire. If a fire occurs,
immediately turn off gas supply at LP tank valve. (See representative illustration in Fig.1.)
Note
: Spiders and small insects can spin webs and build nests inside the burner. This especially
occurs in late summer and fall before frost when spiders are most active. These nests can obstruct
gas flow and cause a fire in and around the burner and orifice. Such a fire can cause operator injury
and serious damage to the appliance.
To help prevent a blockage and ensure full heat output, clean and inspect burner tube often (once or
Air damper
D
