Riverbed SteelCentral NetExpress, Руководство по установке

Страница: 31 / 38

SteelCentral™ NetExpress Appliance Installation Guide 27
CHAPTER 7
Installation verification
Installation verification requires NetExpress to be receiving traffic data from at least one source. To determine if it is
receiving data, log in to the web user interface and navigate to the System > Devices/Interfaces page. Check the status
of Flow Gateway, NetShark or other data source devices on the Devices tab. When a data source comes on line,
NetExpress begins collecting data.
If no data sources are listed on the System > Devices/Interfaces page Devices tab, then the NetExpress installation and
configuration cannot be verified. Set up at least one data source device (preferably all data source devices) and then
perform the installation verification as follows.
1. Go to the Dashboard page and verify that the graphs display data.
2. Go to the System > Information page and assure that all status indications are displaying OK .
3. Go to the System > Devices/Interfaces page and assure that each data source that is expected to be available is listed
and that no status indicators are red.
4. Go to the Reports > Traffic page.
5. Near the bottom of the Report Criteria section, click Run now .
6. Verify that a traffic report is displayed. (It will take a short time for the report to display.)
This completes the installation process. NetExpress can now be turned over to those who are responsible for setting up
user accounts and operational parameters. Refer to the on line help system for further configuration procedures.