RITE-HITE APB-1000, Руководство пользователя

Страница: 12 / 44

6
Pub. No. 1120-R5 — June 2000
1"
Clearance
Bumper
Steel Bumper
Mounting
Right Hand
Side Curb Angle
NOTE: Only B+
6' and 6.5'
Wide Levelers
Have 3 Posts.
All Others
Capacities Have
5 Posts.
Weld Three Or Five Shims Under Support Posts,
Depending On Width And Capacity, Prior To Installation.
Shim Size 3" Wide x 4" Long x Height*.
(2 Shim Packs)
4" x 6" x Height*
Mount Directly
Beneath The Cylinder
Clevis And Weld
To Frame.
8"
4"
6"
1-3/4"
Full Weld Both Sides
(4 Shim Packs)
TOP VIEW
Pit Without Leveler
Top Rear Pit Angle
NOTE: If No Shimming Is Required At Front Frame Angle,
A Minimum 3/8" x 6" Long Fillet Weld Is Required At The
Four Locations Shown.
All Welds Are 3/8" Minimum, Unless Otherwise Indicated.
Refer To AI-1827 Page 2 For Installation Of Deep Pit Conversion.
Reference AI-1837 For Deep Pit Frame Conversion.
*Height Of Shim Pack Will Vary Depending On Pit Depth.
Dock Floor Top Of Leveler
Level
Rear Front
Shipping
Bands
Lip
Keepers
Shims
Pit Floor
Front Curb Angle
Rear
Support
Post
NOTE: Install
Bumpers With
Laminations
Vertical.
1"
TOP VIEW
With Leveler In Pit
6" Long Behind Hinges
(3 Or 5 Places,
Depending On Width)
NOTE: Installation May Be Done
From Dock Floor Or Driveway.
Dock Floor
Top Rear Curb Angle
Side Curb Angle
Pit Floor
Dock Face
Front Curb Angle
Lip Keepers For Levelers With
18" Or 20" Long Lips Are “Tack
Welded” To Inside Of Frame For
Shipping. These Must Be Field
Installed. See AI-1837.
Power
Cord
Pit
Leveler
Lip
Shipping
Bands
Top Of
Leveler
Top Of
Leveler
Handling
Plate
SIDE VIEW
Front Rear
Motor
Frame
Suggested Handling Plate
(Supplied By Others)
Mat’l.: 3/8" x 3" x 8" Long H.R.S.
1-1/2"
2-1/2"
1-3/4"
3"
15
°
1"
1" Dia. Pin 2" Lg.
8" Flat
2"
Dia.
3/8"
C
L
Directly Beneath Front Frame Angle In Line With
Header Stops, Snubbing Cable And SAFE-T-STRUT™.
Shim Size 3" Wide x 4" Long x Height*.
FIGURE 4 — INSTALLATION DETAILS
INSTALLATION DETAILS
APB-1000/Rev5 6/1/00 7:48 AM Page 6