Secondary/Master/
that utilizes ATA commands and the ATA bus to allow
Slave UDMA
DMA commands to transfer data at a maximum burst
rate of 33 MB/s. When you select Auto in the four IDE
devices that the internal PCI IDE interface supports),
the system automatically determines the optimal data
transfer rate for each IDE device.
The choice: Auto, Mode 0, Mode 1, Mode 2, Mode 3,
Mode 4.
IDE Burst Mode
Selecting Enabled reduces latency between each
drive read/write cycle, but may cause instability in IDE
subsystems that cannot support such fast performance.
If you are getting disk drive errors, try setting this value
to Disabled. This field does not appear when the
Internal PCI/IDE field, above, is Disabled.
The choice: Enabled, Disabled.
IDE HDD Block
The chipset contains a PCI IDE interface with support
Mode
for two IDE channels. Select Enabled to activate the
primary and/or secondary IDE interface. Select Disabled
to deactivate this interface, if you install a primary and/or
secondary add-in IDE interface IDE interface.
Enabled
Secondary HDD controller used
Disabled
Secondary HDD controller not used
_______________________________________________________________
3-22
__________________________________
【
【
【
【
3
】
】
】
】
Onboard FDD
This should be enabled if your system has a floppy disk
Controller
drive (FDD) installed on the system board and you wish
to use it. Even when so equipped, if you add a higher
performance controller, you will need to disable this
feature.
The choice: Enabled, Disabled.
Onboard Serial
This item allows you to determine access onboard
Port1/Port2
serial port 1/port 2 controller with which I/O address.
