Issue 3
Royale - Freestanding ETR
- 4 -
Issue 3 - ©Rinnai
Setting the Clock
When the appliance is first plugged in or after a power failure, the digital display with show
--:--
As an example, let’s set the clock to 10:35 am;
Press the SET TIMES button once, the Clock indicator will flash.
Press and hold the “
” button; the minutes will begin to change first then the time will change
by whole hours.
Release the button when AM 10:00 shows on the Digital Display. Confirm that you have
selected AM, a small indicator on the left hand side of the Digital Display indicates the AM
setting.
Press and hold the “
” button again, release the button when AM 10:35 shows. If you go past
AM 10:35, then the “
” button can be used to change the time settings in reverse.
Press the Timer Set button five times to lock in and complete setting the time. The Clock and
Timer indicators will go out. A small indicator on the Digital Display will flash to show that the
Clock is operating.
Programming the ON / OFF Timers
Before programming the Timers you must ensure that the clock has been set to the
correct time.
As an example, let’s program Timer 1 to heat the room by 7:10 am and finish at 9:00 am.
Press the Set Times button twice. The Digital Display will show AM 6:00. Timer 1 indicator will
flash.
Press the “
” button until AM 7:00 appears, release the button, then press it again until AM
7:10 appears. (Press the “
” button if you go past AM 9:00).
Press the Set Times button three times to lock in the program time. The Digital Display will
show the current time. A small indicator on the Digital Display will flash to shown that the
display has returned to the clock.
Timer 2 is programmed in the same way, remember to ensure that the Timer 2 indicator is
flashing when you program in the desired setting. The Timers can be programmed to operate
for any two periods in any 24 hours.
Turn to the next page to operate the dual timer. The programmed time must be selected and
locked-in within one minute of the On Timer indicators flashing otherwise the programmed
times will not be retained in the system memory.
CUSTOMER INFORMATION - SETTING THE CLOCK
