Rinnai RGP-43SV, Руководство по эксплуатации

Страница: 13 / 16

4 TROUBLESHOOTING
•
Fault/Error Identifi cation and Remedy
WARNING
If you notice something abnormal while in use, immediately
stop using this product and shut off the gas valve.
Symptom
The fl ame is not ignited.
It is hard to ignite.
•
Is the gas valve fully opened?
Cause
It is hard to ignite (from
pilot burner to main burner)
Explosion-like ignition
The burner does not turn
red when heated.
•
Is the gas valve fully opened?
•
Is the fl ame detection part of
the fl ame failure device dirty?
•
Is the fl ame holes on the
burner clogged?
•
Fully open the gas valve.
Action to be taken
•
Fully open the gas valve.
•
Clean the fl ame detection
part.
•
Clean the clogged fl ame
holes on the burner.
The fl ame goes off
while using.
•
Is the burner control knob fully
opened?
•
Is the gas valve fully opened?
•
Is the fl ame holes on the
burner clogged?
•
Is the fl ame detection part of
the fl ame failure device dirty?
•
Fully open the burner control
knob when using.
•
Fully open the gas valve.
•
Clean the clogged fl ame
holes on the burner.
•
Clean the fl ame detection
part.
If the problem still persists even after you have checked the above items, stop using the griller
immediately and contact your dealer or any Rinnai offi ce.
The phenomenon outlined below is not a failure of the appliance.
Symptom Cause and action
The main burner goes
out once the hand is
released from the
knob after ignition.
•
If the burner goes out when the hand is released from the burner
control knob, it means the knob was not kept pushed in and turned long
enough. Repeat the ignition operation once again. At this time, hold the
knob longer and release your hand from the knob slowly.
Flame failure device
•
Flame failure device is a safety device to shut off the gas automatically in the event the fl ame of the main
burner goes out.
•
What to do if the fl ame failure device is activated?
When the
fl ame goes out
while in use
To re-ignite the
burner
Turn the burner control
knob back to the
position immediately.
Wait for a while until no gas is
suspended around the griller
and wipe off the dirt on the fl ame
detection part before resuming
the use of the griller.
N
o
te
s
•
Ignition may become harder if dirt or
foreign objects accumulate on the
fl ame failure device (fl ame detection
part). Remove the dirt or foreign objects.
•
Do not allow any hard object to come
into contact with the fl ame detection
part. It can cause deformation and may
result in ignition problems.
- 12 -