2
BEFORE USING THE GRILLER
•
Preparation Before Use
•
Ensure that the type of gas
(gas group) supplied is same
as the one mentioned on the
nameplate of the appliance.
Gas valve
•
Prepare a dedicated gas valve for this appliance.
•
If there is no gas valve in the installation location or the gas valve is not appropriate, the gas valve needs
to be newly installed, relocated or replaced. Consult your dealer or gas operator.
Gas connection
•
The connection port diameter is
ø9.5mm hose end.
RGP-46: Natural gas
Gas other than LP gas:
ø13mm hose end
RGP-46SV
For LP gas: ø9.5mm hose end
For natural gas: ø13mm hose end
•
Use a gas rubber hose and make
it shorter as much as possible
(up to 2m with reasonable margin)
to avoid twist or bend. Do not
place the rubber hose under the
griller. Avoid contact between
hose and the griller.
•
Push the rubber hose onto
the fitting up to the red line
and secure it with a hose
clamp.
•
Do not connect additional
rubber hose or branch out
the hose.
•
Use a gas rubber hose only.
Never use any vinyl hose.
(Vinyl hose is not resilient
and vulnerable to heat.) The
hose with any crack or loose
connection problem must be
replaced with new one.
•
When a fuse cock is used,
select the one appropriate for
the gas type and gas amount
to be used.
•
Gas pipe work requires specialist qualifications and expertise. Consult your dealer.
•
Gas connecting screw of 15A (R1/2) is available by removing the hose end of the griller.
Installation
•
Rectify the shaky griller by adjusting the legs at four corners on the bottom to ensure the level installation.
Check the type of gas supplied
Gas connection and installation
- 6 -
Example) 08.12
(Manufactured on December 2008)
Confi rm the gas type
(Model name)
(Manufactured date)
(Type of gas (gas group))
(Distributor)
(Serial No: )
<Nameplate>
Содержание RGP-43SV
Страница 15: ......