Rinnai REU-2007W, Руководство по обслуживанию

Страница: 18 / 69

))*2!,/
Please do not adjust the DIP Switch Positions before reading this information
The dip switches are provided so that the water heater can be set to different operating
configurations. In some instances such as nursing homes or even domestic situations, it may be
necessary to limit the temperature of the hot water coming from the units.
The set-up configuration for the water heater differs depending on:
• Gas type
• Maximum water flow select
• Temperature limiting requirements
• Alternate type
2/!,;+
Top switch settings 1 ~ 8
1 : Gas type (used only during conversion)
2 : To select maximum water flow volume
3 to 5: To select fixed temperature without remote
6 to 8: To select maximum temperature with remote connected
4 to 8 for modified PCB (see settings). To select the temperature
with or without remote connected.
Note: PCB were modified in April & May 1999 to accommodate
the temperature flow switch to operate without control (see for
settings). Dip switch settings for temperature with or without
controls have changed since modifications. Please check serial
number prior to adjusting.
Bottom switch settings 1 ~ 3
1 : Factory use (To select the capacity of appliance)
2 & 3: Combustion control
The Infinity model series are delivered with maximum hot water temperature limited to 55
C,
however the maximum temperature of hot water can be fixed to 40 C, 43 C, 50 C, 55 C, 60 C, 65 C, or
75 C.
A further maximum temperature of 85
C can be achieved only on the Heavy Duty 20 without a remote
control connected, refer page 16 for specific details.
°
° ° ° ° ° °
°
°