12
|
Continuous Flow Water Heater Operation Guide 04-12
Bathroom Deluxe controller
Avoid getting water directly into the speaker as this may cause damage.
SOUND VOLUME BUTTON
SHOWER SAVER
/ BATH FILL BUTTON
ON/OFF BUTTON
Used to select clock setting mode.
Used to select voice and audible tone
options.
CLOCK SETTING BUTTON
WATER VOLUME BUTTONS
Used to select Shower Saver/Bath Fill
volumes.
TEMPERATURE BUTTONS
CLOCK & REMINDER VOLUME
INDICATOR
SPEAKER
TRANSFER BUTTON
DIGITAL
MONITOR
WATER HEATER ‘In Use’
INDICATOR
SHOWER SAVER / BATH FILL
INDICATOR
WATER TEMPERATURE
INDICATOR
WATER VOLUME INDICATOR
Indicates the selected hot water
temperatures.
Indicates the water heater is in
operation and delivering hot water.
Indicates Shower Saver/Bath Fill volume
selected.
Used to selected Shower Saver/Bath Fill
function.This button is illuminated when
this function is selected.
Used to switch the water heater on and
off. This button is illuminated when the
water heater is on.
Indicates the Shower Saver/Bath Fill
function has been selected and that a
shower is running or the bath is filling.
Used to transfer priority between
controllers. The controller with priority
has command of the hot water
temperature. This button is illuminated
when the controller has priority.
12 hour AM/PM clock display.
Indicates how much water still needs to
flow for the selected Shower Saver/Bath
Fill volume, decreasing while the shower
runs or the bath fills.
In the event of a fault, error message
codes will flash here.
In normal Shower Saver/Bath Fill modes
these buttons are used to select the
water temperature.
In clock mode these buttons are used to
set the clock.-
Turning on
If the water controller is switched
off (no digits displayed in the
digital window) press the On/Off
button once.
The On indicator will illuminate,
indicating the continuous flow
water heater will be ready to supply
hot water once a hot water tap is
opened.
If more than one controller is fitted
press the ‘Transfer’ button once
to transfer priority to the desired
controller.
Setting the clock
The clock is a 12 hour AM/PM
display. To set the time press the
‘Clock’ button once. In the digital
monitor the clock digits will flash,
if this is the first time the clock has
been set the starting time will be
AM 12:00.
Use the up and down buttons to
select the desired time. Holding
these buttons down continuously
cycles the digits. When you get
close to the time you wish to set,
press the button intermittently
to avoid going further than the
desired time.
To return to normal mode,
press the ‘Clock’ button once.
If no buttons are pressed for
approximately 10 seconds the
controller will return to normal
mode.
The time is always displayed
regardless of whether the
controller is turned On or Off.
The clock may need resetting
if power to the water heater is
disrupted due to a power failure or
if the power is switched off over a
prolonged period.