Continuous Flow Water Heater Operation Guide 04-12
|
11
Kitchen Deluxe controller
The Kitchen Deluxe controller is not water resistant, avoid direct exposure to water or
steam as these conditions may cause damage.
ON/OFF BUTTON
DIGITAL
MONITOR
WATER HEATER
'In Use' INDICATOR
SPEAKER
UP AND DOWN BUTTONS
MODE BUTTON
WATER TEMPER ATURE
INDICATOR
SHOWER SAVER /
BATH FILL INDICATOR
CLOCK
TRANSFER BUTTON
Indicates that the Shower Saver /
Bath fill function is operating.
Indicates the selected hot water
temperature.
Used to switch the water heater on and
off. This button is illuminated when the
water heating system is on.
When in normal mode these
buttons are used to select the
water temperature.
In setup mode these buttons are
used to adjust the voice prompt
volume and set the clock.
Used to switch the controller
between normal, voice or clock
modes.
Used to transfer control priority
between the controllers. The
controller with priority has
command of the hot water
delivery temperature. This button
is illuminated when this controller
has priority.
Indicates the water heater is in
operation and delivering hot water.
12 Hour AM/PM clock display.
In the event of a fault, error
messages will flash here.
Turning on
If the water controller is switched
off (no digits displayed in the
digital window) press the On/Off
button once.
The On indicator will illuminate,
indicating the continuous flow
water heater will be ready to supply
hot water once a hot water tap is
opened.
If more than one controller is fitted
press the ‘Transfer’ button once
to transfer priority to the desired
controller.
Setting the clock
The clock is a 12 hour AM/PM
display. To set the time press the
‘Mode’ button twice. In the digital
monitor the word ‘Clock’ will be
displayed and the clock digits will
flash, if this is the first time the
clock has been set the starting
time will be AM 12:00.
Use the up and down buttons to
select the desired time. Holding
these buttons down continuously
cycles the digits. When you get
close to the time you wish to set,
press the button intermittently
to avoid going further than the
desired time.
To return to normal mode,
press the ‘Mode’ button once.
If no buttons are pressed for
approximately 10 seconds the
controller will return to normal
mode.
The time is always displayed
regardless of whether the
controller is turned On or Off.
The clock may need resetting
if power to the water heater is
disrupted due to a power failure or
if the power is switched off over a
prolonged period.
Setting the sound options
Voice prompts are only available
when Bathroom Deluxe controllers
are installed. To set the sound
options press the ‘Mode’ button
once to place the controller into
voice mode. Use the up and down
buttons to select the audible
setting as follows:
-
Voice high, med., low or off,
sets the voice prompt volume
but does not affect the ‘beep’
sound when pressing the
buttons.
-
Sound off mutes all voice
prompts and audible tones.
To return to normal mode, press
the ‘Mode’ button once, if no
buttons are pressed for approx. 10
seconds the controller will return
to normal mode.
Adjusting the temperature
Select the desired temperature
using the ‘Hot water temp.’ up and
down buttons until the required
temperature is displayed.
Once the hot water is running, if
the set temperature is too hot or
cold, press the ‘Hot water temp.’
up and down buttons until the
desired temperature is reached.
With the water running the
temperature can be adjusted down
as desired, but as a safety feature
can only be adjusted up as far as
43 °C. To increase the temperature
above 43 °C, first stop the water
flow.
