Rinnai HD210E, Руководство по эксплуатации и установке

Страница: 20 / 24

Rinnai 20 Commercial Manifold Pack OIM
MANIFOLD PACK PREVENTATIVE MAINTENANCE
Your Rinnai Continuous Flow water heaters have self diagnostic capability. If a fault occurs, an Error Code will flash
on the status monitor or inbuilt controller. If you have Water Controllers, this assists with diagnosing the fault and
may enable you to overcome a problem without a service call. Please quote the code displayed when enquiring
about service.
HD Fault Codes
Code
Description Remedy
- Noticeable reduction in water flow Inlet water filter needs to be cleaned - Service Call
03
Power interruption during Bath fill
(Water will not flow on power reinstatement)
Turn off all hot water taps Press On/Off twice
05 By-Pass Flow Control Failure Service Call
10
Air Supply or Exhaust Blockage
or Condensate Pipe Blockage
Service Call
11 No ignition / No gas supply
Check gas is turned on at water heater and gas
meter or cylinder
12 Flame Failure / Low gas flow
Check gas is turned on at water heater and gas
meter or cylinder. Check there are no obstructions
to the flue outlet
14
Heat Exchanger Overheat Failure Service Call
15 Venturi Control Failure Service Call
16 Over Temperature Warning Service Call
17 Venturi Blockage Service Call
19 Electrical Earthing Failure Service Call
21 Data Transfer Error Service Call
32 Outgoing Water Temperature Sensor Failure Service Call
33 Heat Exchanger Thermistor Failure Service Call
34 Combustion Air Temperature Sensor Failure Service Call
38 Exhaust Thermistor Failure Service Call
41 Freeze Protection Thermistor Failure Service Call
51 Inlet Thermistor Failure Service Call
52 Gas Valve Failure Service Call
54 High Exhaust Gas Temperature Failure Service Call
S5 Scheduled Service Reminder Service Call
Se Cascade Connection Failure Service Call
61 Combustion Fan Failure Service Call
65
Water Flow Control Failure
(Does not stop flow properly)
Service Call
70 PCB Failure Service Call
71 Solenoid Valve Circuit Failure Service Call
72 Flame Rod Failure Service Call
Wireless water controller (when fitted) is ‘Out of
Range’ due to the distance from transceiver or an
obstruction.
Move wireless water controller or transceiver or
remove the obstruction.
FAULT FINDING