Rimage Prism III, Руководство пользователя, Страница: 23 / 161

20
Maintain the Prism III Printer
For more information visit
rimage.com/support 2001809_A
5. Install the take-up roller in the Prism and press down firmly until the
take-up roller snaps into place. The ribbon should be tight and there
should be no creases in the ribbon.
Important! Do not roll the STOP – Wind Leader Onto Take-up Core
Stopping Here marking on the ribbon leader onto the take-up roller.
The marking should not be past the point shown in the picture. If the
marking is on the roller, pull the take-up roller out and roll back the
ribbon. Roll the supply roller back to take up the slack.
6. Press the operator button and hold for 5 seconds to allow the printer to
validate the ribbon. If the ribbon is valid the printer advances and the
Error indicator light stops blinking.
Note: During the ribbon validation process, the ribbon cycles past the
ribbon leader. After the ribbon validation process is complete, make sure
that the ribbon is wound tight.
7. Install the top cover .
Ribbon Leader
Take-up Roller Marking