Rimage Prism III, Руководство пользователя, Страница: 22 / 161

19
Maintain the Prism III Printer
For more information visit
rimage.com/support 2001809_A
3. Install the supply roller as shown. Leave some slack in the ribbon leader.
a. Press the
operator button
until the printer
tray comes out.
The ribbon is
threaded to
the front of the
Prism.
b. Remove the
ribbon leader from the installation clamp.
c. Remove the adhesive strip from the ribbon leader .
4. Load the take-up roller .
a. Place the
new empty cardboard core
on the
take-up roller
. It is
designed to fit only one way.
b. Place the
take-up roller
on top of the
ribbon leader
as shown.
Important!
The gear must be on the correct side.
Cardboard Core
Ribbon Leader
Gear
Adhesive Strip
c. Pull the ribbon leader up
over the cardboard core .
d. Attach the adhesive
strip to the cardboard
core so that the edges
on the ribbon leader are
aligned to the edges of
the cardboard core.
e. Roll the ribbon leader so
that it is wrapped only
once around the roller.
Important! Do not roll past the marking on the leader that states
STOP - Wind Leader Onto Take-up Core Stopping Here for
monocolor ribbons. If you are using a CMY ribbon, roll up to the end
of the yellow leader.
Supply Roller