Riland CUT 100GT, Руководство пользователя, Страница: 7 / 20

7
The wire end may deal damage, please note the following.
˜
Never look into the electric conduction hole when checking the wire feeding is normal or not, ,
or the shooting wire may stab your eyes and face.
˜
Keep your eyes, face or other naked parts away from the end of torch when feeding the wire
manually or pressing the switch.
For better work efficiency and power source maintenance, please
note the following.
˜
Precautions against toppling over.
˜
Never use the cutting equipment for pipe thawing.
˜
Lift the power source from side when use the up-down forklift truck to avoid toppling over.
˜ When using the crane for lift, tie the rope to the ears with an angle no more than φ15 to the
vertical direction.
˜
When lifting the plasma cutting machine which equipped with gas cylinder and wire feeder,
download them from the power source and ensure the horizontal of the machine. Do fix the gas
cylinder with belt or chain when moving it to avoid body hurt.
˜
Ensure fastness and insulation when lifting the wire feeder through the swing ring for cutting.
Lifting way for the machines with swing ring on the top
（
φ≤15°
）
Electromagnetic interference needing attention.
˜
It may need extra preventive measures when the equipment is used in particular location.
˜
Before the installation, please estimate the potential electromagnetism problems of the
environment as follows.
a) Upper and lower parts of the cutting equipments and other nearby power cable, control cable,
signal cable and phone cable.
b) Wireless electric as well as TV radiation and reception equipment.