Rigmaster MTS-T4-LGN, Руководство пользователя

Страница: 26 / 56

LGN Owner's Manual Cabin Controller
Page 24
LGN-Owners-Manual-071520
CODE REMEDY/CAUSE REMEDY/COMMENT
Error Code 14
Check External
Temperature
Sensor
External temperature.
sensor may not be
connected to the power
module.
•
External temperature sensor
disconnected or failed.
•
Connection loose or damaged.
Error Code 15
External Temp
Disable Limit
Engine shut down due
to external temperature
outside the
programmed range.
•
The APU has been
programmed not to start when
the external temperature is
outside a preprogrammed
range.
Error Code 16
Module Reset
–
Set Clock
Power to the cabin
controller has been lost.
•
Reset clock.
Error Code 17
Low Oil Level
Oil level is low
Adjust oil level
•
Check and adjust oil level as
needed.
•
Check for broken signal or
ground wire
•
If wires are OK, replace sensor
Error Code 18
Replace Exhaust
Filter (for unit
equipped with
Diesel Particulate
Filters)
Replace exhaust filter if
unit is DPF equipped; if
not DPF equipped, then
power module failure
likely.
•
See authorized Dealer for
exhaust filter replacement or
power module
diagnosis/replacement.
Error Code 19
Please Register
Unit
Unit will run for four (4)
hours after installation.
Registration code must
be entered into the
cabin controller display
keypad.
•
To obtain registration code,
please call the APU
Manufacturer (1-800-249-6222)
with the serial # of your unit.
There is no charge for this
service.