Rigmaster MTS-T4-LGN, Руководство пользователя

Страница: 19 / 56

LGN Owner's Manual Cabin Controller
Page 17
LGN-Owners-Manual-071520
Operation of the Cabin Controller (Functions)
To Turn Power On
Press the
POWER button to activate the system. When the power switch is
activated the LCD display will light and SYSTEM ON symbol will turn on (active
mode). Press POWER button again for 2 seconds to switch the unit back to low
power mode.
Engine Start
Press
START button.
The control panel will display the status of the operation as it occurs: Glow Plug
and a countdown will display on the screen. Once the countdown is complete
the display will read Cranking as the APU starts up and the ENGINE RUNNING
symbol will blink. Once started the control will display Engine Running for 5
seconds (and ENGINE RUNNING symbol will turn on).
Engine Stop
Press
STOP button.
The screen will initially display Stopping and then change to Stopped once the
operation is complete. The Engine Running symbol will turn off.
Temperature Control
Press UP or DOWN (red/blue) buttons to adjust temperature set point on the
display. When editing the set point, the LCD display will show the set point
instead of internal cabin temperature. The set point is stored without a need to
press any other buttons.
NOTE
The manual temperature control ranges from 59ºF to 90ºF (15ºC to 32ºC).
The system will remember the last set temperature when the APU is turned
on. If the system is already running, the change will take effect a few seconds
after the last UP or DOWN key is pressed, and the display will switch back
from set point to internal cabin temperature.