Rigmaster MTS-T4-LGN, Руководство пользователя

Страница: 24 / 56

LGN Owner's Manual Cabin Controller
Page 22
LGN-Owners-Manual-071520
FAULT CODES
The LGN
’s electronic control will display fault codes on the LCD display if the unit
fails to start or shuts down. The following table contains fault codes and
information on the cause and/or remedy. These fault codes will display one time
only; if the code is cleared from the cabin controller, failure will have to reoccur
for the code to be displayed again.
CODE REMEDY/CAUSE REMEDY/COMMENT
Error Code 1
Safety Cover
Open
Engine cover of APU
unit is open. APU will
not start or run until the
cover is closed.
•
Cover not seated.
•
Damaged wiring.
•
Failed cover switch.
•
Switch out of adjustment.
Error Code 2
Low Engine
Pressure/Air Filter
Replacement
Low oil pressure or air
filter is blocked
.
•
Low oil level.
•
Wiring damaged.
•
Faulty switch.
•
Dirty air filter.
Error Code 3
Battery Low
Voltage
Low battery voltage.
Start system
immediately to charge
batteries.
•
Damaged or broken battery
cables; failed battery.
•
Excessive load on batteries.
•
Faulty charging system.
Error Code 4
Engine Run
Failure
Engine may have
started but didn’t run
properly. “AutoStart” is
disengaged; attempt
manual starting with
START button.
•
Speed sensor adjustment
(set air gap at 0.015").
Damaged speed sensor wiring.
•
Failed speed sensor.
Error Code 5
Low Coolant/
Engine
Overheated
Engine will not run until
temperature becomes
normal or coolant level
is at full in surge tank.
•
Low coolant or failed coolant
level switch.
•
High engine temperature or
failed engine temperature
sensor (top of water pump, has
single wire).
•
Damaged wire providing
ground.
Error Code 6
Module Failure
Power Module is not
responding.
•
Failed power module.