Rigmaster MTS-T4-LG200, Руководство по установке

Страница: 55 / 62

RigMaster LG200 Installation Manual Section 11
August 2010 RigMaster Power International Ltd LG200 Service Manual
Register this RigMaster Installation Check List at
www.rigmasterpower.com/login
11:6:1
LG200 Installation Check List
Date Inspected RigMaster Model No. RigMaster Serial No.
Vehicle Make/Model/Year RigMaster Engine Model No. RigMaster Engine Serial No.
Installing/Certifying Dealers Name Inspecting Technician Invoice No
In-Service Date APU Hours Reading Owners Name
Owners Phone Number Owners Address Owners Signature
LG200
Unit Comments
Make sure the LG200 is straight with the truck’s frame.
Keep 2 1/2 inches on the right side of the LG200 for
clearance. You will need room to attach the a/c quick
connect to the two charge port fittings.
Cables/Hoses
Make sure all hoses are secure using tie cables.
Make sure that the coolant/fuel hoses are not pinched when
using the tie cables.
Make sure there is loom around the cables/hoses that might
have a chance to rub on the truck’s frame or brackets.
Muffler Assembly
If the muffler tail pipe is located under the bunk then
additional piping must be added to avoid exhaust entering
the cab.
HVAC Box/Control Panel
Make sure all ground wires are secured to the HVAC box.
Make sure a grommet or loom is used to protect the
cables/hoses where they pass through the vehicles floor.
Make sure the holes drilled through the floor are sealed.
Note: Add sealant to the outside of the bunk & inside the
cab. This will keep moisture from entering the cab.
Make sure that the control panel is not placed in a location
that the vent is blowing air directly at the controller.
Note: If
the vent is blowing air directly towards the controller a false
temperature reading will displayed.
Start-Up Procedures
Start the LG200. Note: Check oil & coolant level first
Check for heat and air conditioning in the bunk.
See that the alternator is charging the batteries.
Check for any leaks as in coolant and engine oil.