Rigmaster MTS-T4-LG200, Руководство по установке

Страница: 47 / 62

RigMaster LG200 Installation Manual Section 11
August 2010 RigMaster Power International Ltd LG200 Service Manual
11:2:2 Operation of the Cabin Controller (Functions)
To Turn Power On
Press the POWER button to activate the system. When the power switch is activated
the LCD display will light and SYSTEM ON symbol will turn on (active mode). Press
POWER button again for 2 seconds to switch the unit back to low power mode.
Engine Start
Press START button.
The control panel will display the status of the operation as it occurs: Glow Plug
and a countdown will display on the screen. Once the countdown is complete the
display will read
Cranking as the LG200 starts up and the ENGINE RUNNING symbol
will blink. Once started the control will display Engine Running for 5 seconds (and
ENGINE RUNNING symbol will turn on).
Engine Stop
Press STOP button.
The screen will initially display Stopping and then change to Stopped once the
operation is complete. The Engine Running symbol will turn off.
Temperature Control
Press UP or DOWN (red/blue) buttons to adjust temperature set point on the
display. When editing the set point, the LCD display will show the set point instead
of internal cabin temperature. The set point is stored without a need to press any
other buttons.
NOTE
The manual temperature control ranges from 59°F-90°F (15°C to 32°C).
The system will remember the last set temperature when the LG200 is turned on.
If the system is already running, the change will take effect a few seconds after
the last UP or DOWN key is pressed and the display will switch back from set
point to internal cabin temperature.
Clock & Date Set Up
It is necessary to enter the time and date programming mode if the module has
never been programmed or a different time zone is required. (
SET symbol is
flashing and CLOCK symbol is turned on during clock setup)
Press CLOCK button:
The display will read Set Clock. Press SELECT button to continue, MODE to
exit.
Clock hour will start flashing.
Press LEFT or RIGHT scroll button to adjust Clock hour .
Press SELECT button: Clock hour will stop flashing and Clock minutes will start
flashing.
Press LEFT or RIGHT scroll button to adjust
Clock minutes .